Click to enlarge
ISO-NOPNM NITRIC OXIDE SENSOR - 100NM $1,074.00
Back to products
ECG REFERENCE CELL $74.00

ECG PROBE

$620.00

Compare
Add to wishlist
Сatalog number: ECG-PROBE Categories: , , ,
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “ECG PROBE”

Your email address will not be published. Required fields are marked *

Shipping & Delivery

Related products

Compare
Сatalog number: 5375

Low-noise cable for Microelectrode Holder, A: BNC (male), B: jack

, , , ,
$59.00
For wiring any laboratory setup This standard cable has a male BNC connector on one end and a 2mm gold
Add to wishlist
Add To Quote
Quick view
Compare
Сatalog number: 300040

Adapter Extension, Connector B: 2 mm socket

, , , , ,
$112.00
  • Connector A: 2 mm socket
  • Connector B: 2 mm socket
  • Cable: 4 in. (10 cm)
Add to wishlist
Add To Quote
Quick view
Compare

Single Channel Pulse Generator

, , ,
$3,602.00 – $4,147.00
The A310 pulse generator/stimulator combines the reproducibility and accuracy of digital electronics with the fine resolution and continuous adjustment pos­si­ble with analog circuitry. All timing pa­ram­e­ters are entered with high resolution, ten-turn po­ten­ti­om­e­ters and six-position range switches. Timing is ac­cu­rate to within 1% of the set value.
Add to wishlist
Add To Quote
Quick view
Compare
Сatalog number: 503043

UNIVERSAL POWER SUPPLY (12V DC), 5.5X2.1MM

, , , , ,
$35.00
This power supply is used as EVOM2 charger. Learn More
Add to wishlist
Add To Quote
Quick view
Compare
Сatalog number: TIDAS-D2

Deuterium Replacement Lamp

, ,
$1,179.00
  • For use with TIDAS-2
Add to wishlist
Add To Quote
Quick view
Compare
Сatalog number: 5373

Low-Noise Cable for Microelectrode Holder, A: pin/jack, B: pin/jack

, , , ,
$35.00
Standard electrophysiology application cable
This cable has a pin/jack connector on both ends and is 2' (0.6m) long.
Add to wishlist
Add To Quote
Quick view
Compare
Сatalog number: 300102

Adapter Extension, Connector B: 0.31 mm socket

, , , ,
$132.00
Connector A: 2 mm socket Connector B: 0.31 mm socket Cable: 4 in. (10 cm) Learn More
Add to wishlist
Add To Quote
Quick view
Compare
Сatalog number: BRIDGE8

Bridge8 Transducer Amplifier Module

$994.00

Low noise transducer amplifier in a modular system

Bridge8 is a modular, rack-mountable amplifier system. It is specifically designed for use as a signal conditioning amplifier with strain gages and other poered transducers. Bridge8 includes differential amplifiers featuring high input impedance, high common mode rejection and low current leakage input terminals for low noise operation. The Bridge8 also features a half bridge switch and channel offset. A wide variety of WPI transducers are available for force, temperature, pressure and light measurements. The Bridge8 amplifier is a clear choice for convenience and quality. Any combination of ISO-DAM8 or Bridge8 modules may be combined in the same enclosure. The ISO-DAM8A module is also available in this rack configuration.
Add to wishlist
Add To Quote
Quick view