For wiring any laboratory setup
This standard cable has a male BNC connector on one end and a 2mm gold jack on the other end. The cable is 4′ (1.2m) long. Learn More
Low-noise cable for Microelectrode Holder, A: BNC (male), B: jack
Description
Shipping & Delivery
Related products
Сatalog number:
EZ-124DV
Anesthesia Oxygen Output Splitter
Single Channel Pulse Generator
The A310 pulse generator/stimulator combines the reproducibility and accuracy of digital electronics with the fine resolution and continuous adjustment posÂsiÂble with analog circuitry. All timing paÂramÂeÂters are entered with high resolution, ten-turn poÂtenÂtiÂomÂeÂters and six-position range switches. Timing is acÂcuÂrate to within 1% of the set value.
Micro Nitric Oxide Sensors
The ISO-NOP007 has a tip diameter of just 7 microns and a length of 2mm. The response is linear over a wide dynamic concentration range of NO. The design is based on a single carbon fiber coated with WPI's NO-selective membrane. A detection limit of approximately 1 nM NO makes this electrode ideal for use in tissues and microvessels.
Сatalog number:
CPVC4050G
Carbon, 18 AWG, green
Сatalog number:
504716
Extension Cable, Male banana to Micro-clip, 36″
Сatalog number:
5374
Low-noise cable for Microelectrode Holder, A: BNC (male), B: pin
Сatalog number:
5373