TRIO 3-IN-1 ANALGESIA SYSTEM
Get three test systems in one package with the Trio, featuring the Electronic von Frey, Plethysmometer and Randall Selitto meters. Just like the Quattro package, the modular design allows these three test systems to communicate with the same electronic controller. The stand and sling for the Randall Selitto test are sold separately.
Three test systems
- Electronic von Frey
- Plethysmometer
- Randall Selitto
Shipping & Delivery
Related products
Сatalog number:
DRL
Dummy Load Resistor Kit
A365 can be used as a precise voltage source by placing a precision “dummy” resistor load across the output terminals. Precision resistors (such as the 100 Ω, 1000 Ω and 10,000 Ω resistors in WPI’s optional Dummy Load Resistor Kit #DRL) when placed across the output terminals convert the precision current levels to accurate voltage levels.
For example, 1 milliampere flowing through 1000 Ohms will produce 1 volt across the output terminal pair. Thus, models A365D and A365R can be used as low noise sources of accurate voltage pulses or DC. To maintain less than 1% error, avoid shunting the output dummy resistor with a load resistance less than 100 times the dummy resistance value.
Сatalog number:
5374
Low-noise cable for Microelectrode Holder, A: BNC (male), B: pin
Сatalog number:
13685
SP Series Pump-to-Pump Linking Cable
Сatalog number:
5375
Low-noise cable for Microelectrode Holder, A: BNC (male), B: jack
Сatalog number:
TIDAS-D2
Deuterium Replacement Lamp
Micro Nitric Oxide Sensors
The ISO-NOP007 has a tip diameter of just 7 microns and a length of 2mm. The response is linear over a wide dynamic concentration range of NO. The design is based on a single carbon fiber coated with WPI's NO-selective membrane. A detection limit of approximately 1 nM NO makes this electrode ideal for use in tissues and microvessels.