Female Quick Disconnect for Anesthesia
- For use with EZ Anesthesia systems
- 0.25″ hose barb
Shipping & Delivery
Related products
Сatalog number:
TIDAS-D2
Deuterium Replacement Lamp
Сatalog number:
5371
Low-noise cable for Microelectrode Holder, A : pin, B : pin
Micro Nitric Oxide Sensors
The ISO-NOP007 has a tip diameter of just 7 microns and a length of 2mm. The response is linear over a wide dynamic concentration range of NO. The design is based on a single carbon fiber coated with WPI's NO-selective membrane. A detection limit of approximately 1 nM NO makes this electrode ideal for use in tissues and microvessels.
Сatalog number:
5375
Low-noise cable for Microelectrode Holder, A: BNC (male), B: jack
Сatalog number:
CPVC4050G
Carbon, 18 AWG, green
Сatalog number:
DRL
Dummy Load Resistor Kit
A365 can be used as a precise voltage source by placing a precision “dummy” resistor load across the output terminals. Precision resistors (such as the 100 Ω, 1000 Ω and 10,000 Ω resistors in WPI’s optional Dummy Load Resistor Kit #DRL) when placed across the output terminals convert the precision current levels to accurate voltage levels.
For example, 1 milliampere flowing through 1000 Ohms will produce 1 volt across the output terminal pair. Thus, models A365D and A365R can be used as low noise sources of accurate voltage pulses or DC. To maintain less than 1% error, avoid shunting the output dummy resistor with a load resistance less than 100 times the dummy resistance value.
Сatalog number:
504716