2 Optional Shielded Modular Cables for DAM50 Bioamplifier
$143.00
Shielded cable for DAM50
This shielded cable is often used with the WPI DAM50 Bioamplifier. It has an RJ11 connector for the DAM50 input port. The other end is unterminated so you can build the piece you need for you own application. Learn More
Shipping & Delivery
Related products
Сatalog number:
5373
Low-Noise Cable for Microelectrode Holder, A: pin/jack, B: pin/jack
Сatalog number:
504716
Extension Cable, Male banana to Micro-clip, 36″
Сatalog number:
CPVC4050G
Carbon, 18 AWG, green
Сatalog number:
5371
Low-noise cable for Microelectrode Holder, A : pin, B : pin
Сatalog number:
DRL
Dummy Load Resistor Kit
A365 can be used as a precise voltage source by placing a precision “dummy” resistor load across the output terminals. Precision resistors (such as the 100 Ω, 1000 Ω and 10,000 Ω resistors in WPI’s optional Dummy Load Resistor Kit #DRL) when placed across the output terminals convert the precision current levels to accurate voltage levels.
For example, 1 milliampere flowing through 1000 Ohms will produce 1 volt across the output terminal pair. Thus, models A365D and A365R can be used as low noise sources of accurate voltage pulses or DC. To maintain less than 1% error, avoid shunting the output dummy resistor with a load resistance less than 100 times the dummy resistance value.
Micro Nitric Oxide Sensors
The ISO-NOP007 has a tip diameter of just 7 microns and a length of 2mm. The response is linear over a wide dynamic concentration range of NO. The design is based on a single carbon fiber coated with WPI's NO-selective membrane. A detection limit of approximately 1 nM NO makes this electrode ideal for use in tissues and microvessels.