Features
- Connector A: none
- Connector B: none
- Cable: 25 ft (7.6 m)
- 8 conductor 30 gauge stranded wires with shield cable
- Teflon insulated
Cable, shielded transducer stock
$299.00
Popular electrical component
This shielded transducer stock cable has no connectors on either end. it is 25 ft (7.6 m) long. It hasĀ 8 conductor, 30 gauge stranded wires with shield cable, and it is Teflon insulated. Learn More
Description
Shipping & Delivery
Related products
Š”atalog number:
5371
Low-noise cable for Microelectrode Holder, A : pin, B : pin
Š”atalog number:
DRL
Dummy Load Resistor Kit
A365 can be used as a precise voltage source by placing a precision ādummyā resistor load across the output terminals. Precision resistors (such as the 100 Ī©, 1000 Ī© and 10,000Ā Ī© resistors in WPIās optional Dummy Load Resistor Kit #DRL) when placed across the output terminals convert the precision current levels to accurate voltage levels.
For example, 1 milliampere flowing through 1000 Ohms will produce 1 volt across the output terminal pair. Thus, models A365D and A365R can be used as low noise sources of accurate voltage pulses or DC. To maintain less than 1% error, avoid shunting the output dummy resistor with a load resistance less than 100 times the dummy resistance value.
Single Channel Pulse Generator
TheĀ A310Ā pulse generator/stimulator combines the reproducibility and accuracy of digital electronics with the fine resolution and continuous adjustment posĀsiĀble with analog circuitry. All timing paĀramĀeĀters are entered with high resolution, ten-turn poĀtenĀtiĀomĀeĀters and six-position range switches. Timing is acĀcuĀrate to within 1% of the set value.
Micro Nitric Oxide Sensors
TheĀ ISO-NOP007Ā has a tip diameter of just 7 microns and a length of 2mm. The response is linear over a wide dynamic concentration range of NO. The design is based on a single carbon fiber coated with WPI's NO-selective membrane. A detection limit of approximately 1 nM NO makes this electrode ideal for use in tissues and microvessels.
Š”atalog number:
5375
Low-noise cable for Microelectrode Holder, A: BNC (male), B: jack
Tidas-E Base Series Photo Diode Array Spectrometer
WPIās TidasĀ seriesĀ is a high end fiber-optic spectrometer module designed for low noise applications. TheĀ TidasĀ seriesĀ outperforms conventional bench-based spectrophotometers and CCD-based spectrometer modules, when it comes to high precision fiber optic sampling. It relies on a monolithic optical bench made by Zeiss, which is optimized for fiber optic applications. Most cuvette-based standard spectrometers lose more than 90% of light through expensive prism decoupling. The TidasĀ seriesĀ is designed for fiber optic sampling cells. Using suitable light sources and sample cells, spectral detection in the wavelength range of 190 toĀ 1100Ā nm can be performed at noise levels < 0.04 mAU peak to peak.
Š”atalog number:
800496
Universal Power Supply (12V DC), 5.5×2.5mm
Š”atalog number:
13555