Anesthesia/Ventilator Connection Kit
$257.00
Ventilator Connection Kit
This kit is used to connect the CW-SAR-830 ventilators with EZ-Anesthesia Systems. It includes all required components, pre-assembled for simple connection between the ventilator and the anesthesia system, including tubing and fittings.
Shipping & Delivery
Related products
Сatalog number:
5374
Low-noise cable for Microelectrode Holder, A: BNC (male), B: pin
Сatalog number:
300102
Adapter Extension, Connector B: 0.31 mm socket
Сatalog number:
5373
Low-Noise Cable for Microelectrode Holder, A: pin/jack, B: pin/jack
Micro Nitric Oxide Sensors
The ISO-NOP007 has a tip diameter of just 7 microns and a length of 2mm. The response is linear over a wide dynamic concentration range of NO. The design is based on a single carbon fiber coated with WPI's NO-selective membrane. A detection limit of approximately 1 nM NO makes this electrode ideal for use in tissues and microvessels.
Сatalog number:
5371
Low-noise cable for Microelectrode Holder, A : pin, B : pin
Сatalog number:
13555
Serial Cable
Single Channel Pulse Generator
The A310 pulse generator/stimulator combines the reproducibility and accuracy of digital electronics with the fine resolution and continuous adjustment possible with analog circuitry. All timing parameters are entered with high resolution, ten-turn potentiometers and six-position range switches. Timing is accurate to within 1% of the set value.
Сatalog number:
EZ-124DV